And the results that I get when writing these commands in the "Command prompt" are confusing as well. I don't understand why isn't it mentioned in that tip, it is really confusing for a newbie like me. At the beginning in that page it says "These instructions assume basic knowledge of the command line", so I assumed I needed to open a "Command prompt" program for that, is it right ? Now, it's not written WHERE do I have to write these commands. To check if you have the GPG tools installed, run the command gpg -version or gpg2 -version. Tip: On non-Linux systems, you might need to download the GPG tools for this next step. Friends, I would like to specify my question a little bit, cause a lot of you give me suggestions that are already written in this page What confused me is that tip in the 2nd step, where it says :
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |